Build a Fidget Spinner

The materials that you will need first are: 9/16 large nut, one red cable tie, and one 7/16 small nut.

Insert the red cable tie though the 7/16 small nut and into the 9/16 large nut making a loop, then
tighten the red cable tie. (fig.1-2)

Repeat another two times. (fig. 3-5)

Then, insert the Flange bearing into the middle of the three red cable ties. (This might be a little
tight but that’s ok.) (fig. 6-7)

Insert the 2-Sided binding post into the Flange bearing. (fig. 8)

On the opposite side of the fidget spinner add the 1/4 flat washer to the binding post and then
screw the binding head though the 1/4 flat washer and into the binding post. (fig. 9-11)

Cut off the extra part of the red cable ties. (fig. 12-15)

All done! It should look like this: